J9773A Specification
J9773A Specifications |
|
Type |
Aruba 2530-24G-PoE+ Switch |
System specifications |
|
Ports |
|
Memory and processor |
Processor: ARM9E @ 800 MHz, 128 MB flash, 256 MB DDR3 DIMM; packet buffer size: 1.5 MB dynamically allocated. |
Mounting |
Mounts in an EIA-standard 19-inch telco rack or equipment cabinet (rack-mounting kit available); horizontal surface mounting; wall mounting. |
Management |
IMC – Intelligent Management Center; Command-Line Interface (CLI); Web browser; configuration menu; out-of-band management (serial RS-232C or Micro USB);IEEE 802.3 Ethernet MIB; Repeater MIB; Ethernet Interface MIB. |
Performance (IPv6 Ready Certified) |
|
1000 Mb latency |
< 2.3 ?s (LIFO 64-byte packets) |
100 Mb Latency |
< 7.4 ?s (LIFO 64-byte packets) |
Throughput |
up to 41.6 million pps (64-byte packets) |
Switching capacity |
56 Gb/s |
MAC address table size |
16000 entries |
Physical specifications |
|
Dimensions (W x D x H) |
44.3 x 33.02 x 4.45 cm (17.44 x 13.00 x 1.75 in) (1U height) |
Weight |
3.95 kg (8.7 lb) |
Electrical specifications |
|
Maximum heat dissipation |
135 BTU/hr (142.42 kJ/hr), (switch only: 135 BTU/hr; combined switch + max. PoE devices: 843 BTU/hr) |
Voltage |
100 – 127 / 200 – 240 V ac |
Current |
3.2/1.6 A |
Idle power1 |
25.2 W |
Maximum power rating2 |
247 W |
PoE power |
195 W |
Frequency |
50/60 Hz |
NOTE: 1: Idle power is the actual power consumption of the device with no ports connected. 2: Maximum power rating and maximum heat dissipation are the worst-case theoretical maximum numbers provided for planning the infrastructure with fully loaded PoE (if equipped), 100% traffic, all ports plugged in, and all modules populated. PoE power is the total power budget available to all PoE ports. |
|
Environmental specifications |
|
Operating temperature |
0 ? to 45 ?C (32 ? to 113 ?F) |
Operating relative humidity |
15% to 95% @ 40 ?C (104 ?F), noncondensing |
Non-operating/storage temperature |
-40 ? to 70 ?C (-40 ? to 158 ?F) |
Non-operating/storage relative humidity |
15% to 90% @ 65 ?C (149 ?F), noncondensing |
Altitude |
Up to 3 km (10,000 ft) |
Acoustic |
Power: 39.6 dB, Pressure: 43.9 dB |
Safety agency certifications |
|
Safety |
UL 60950-1; CAN/CSA 22.2 No. 60950-1; EN 60825; IEC 60950-1; EN 60950-1 |
NOTE: IEEE 802.3az applies to Gigabit models only; IEEE 802.3at and IEEE 802.3af apply to PoE+ models only. When using SFPs with this product, SFPs with revision “B” or later (product number ends with the letter “B” or later, e.g., J4858B, J4859C) are required. |