HWIC-1CE1T1-PRI Cisco Channelized T1/E1 and ISDN PRI Module
HWIC-1CE1T1-PRI Specification |
|
Description | 1 port channelized T1/E1 and PRI HWIC (data only) Cisco Router High-Speed WAN Interface card |
Diagnostic Loopback Support | ?? E1 loopback modes:
?? Controller local loopback ?? Interface local loopback ?? T1 loopback modes: ?? Interface local loopback ?? Interface remote loopback ?? Controller local loopback ?? Controller remote loopback ?? CSU loopback modes for T1 CSU: ?? Data terminal equipment (DTE) loopback ?? Network loopback ?? Payload loopback |
Alarm Detection | ?? Yellow Alarm-Receive/Send from/to network
?? Blue Alarm-Receive alarm indication signal (AIS) from network ?? Red Alarm-Loss of network signal |
Relevant MIB Support | ?? T1 MIB (RFC1406-MIB)
?? Cisco Integrated DSU/CSU MIB (CISCO-ICSUDSU-MIB) |
Remote Management | ?? Cisco CNS 2100 Series Intelligence Engine (IE2100)
?? CiscoWorks |
Signaling Debugging | ?? ISDN Q.921 and Q.931 decode
?? All other previously existing applicable Cisco IOS Software debugs |
Dimensions (H x W x D) | ?? HWIC-1CE1T1-PRI: 0.75 x 3.08 x 4.74 in.
?? (1.91 x 7.82 x 12.04 cm) |
Weight | ?? HWIC-1CE1T1-PRI: 0.18 lb (0.08 kg) |
Operating Temperature | ?? 32 to 104 ?F (0 to 40 ?C) |
Nonoperating Temperature | ?? -40 to 158 ? F (-40 to 70 ?C) |
Relative Humidity | ?? 5-95% noncondensing |
LEDs | LEDs per port
?? Carrier Detect/Loopback (CD/LP): ?? Off = No carrier detect ?? Green On = Carrier detect ?? Yellow On = Port in loopback mode ?? Alarm (AL): ?? Off = No alarms ?? Yellow On = Port in alarm mode LEDs per module (on NM-8CE1T1-PRI only): ?? EN: ?? Off = Card not available ?? On = Card enabled |
Ports | ?? 1, 2, or 8 T1/E1 ports on RJ-48C connectors |
Line Bit Rate (per Port) | ?? E1: (2.048 Mbps)
?? T1: (1.544 Mbps) |
Line Coding | ?? E1: High-density bipolar three (HDB3 )
?? T1: Alternate mark inversion (AMI) and binary 8-zero substitution (B8ZS |
Framing Formats | ?? E1: CRC4
?? T1: Super Frame (SF) and Extended Super Frame (ESF) |
Output Levels | ?? E1: short-haul/long-haul
?? T1 (line build-out [LBO]): 0, -7.5, or -15 dB |